GUASSIA ASSET ENGINE · CONNECTED MECHANISMS

Make something
that works together.

Follow the gear train from its supported input shaft to the crank, connecting rod and guided slider. Apply motor torque or a slider load, pause the motion, and inspect each connection.

Starts when visible. Pauses off-screen. Reduced-motion preferences are respected.

01

Forces drive the motion

The force-driven mode calculates shaft motion from torque, inertia, mass, gravity, damping and slider load. Ideal joint constraints keep connected parts together. This is a reduced-coordinate teaching model, not a general contact or structural solver.

02

Find every connection

The frame grounds the bearings. Shafts support the gears, the crank drives the rod, and rails constrain the slider. Open Parts & assembly to inspect the assembly and export the separate teaching kit.

03

Keep the evidence clear

Numerical tests check motion, constraints and energy accounting. They do not establish tooth contact, strength, wear or the fit of a real print. The large gear-drive illustration and the small printable crank-slider kit have different geometry.

Build the tabletop crank-slider

The free prototype includes 12 distinct STL parts, quantities, a connection list, a clearance coupon and piece-by-piece instructions. It is an assembled kit with specified M4 screws, lock nuts and washers; hardware is not included.

Open Parts & assembly in the study and choose Download crank-slider print kit. In the installed Asset Engine, open Mechanical study from the visible Studies row. Keep the included ASSEMBLY.txt beside your slicer.

  1. Check the fit first. Print the clearance pin and plate. Test the 0.2, 0.3 and 0.4 mm radial-clearance bores before printing the complete kit.
  2. Prepare every part. Inspect the STL files in millimeters at 100% scale. Print the listed quantities flat, deburr moving surfaces, and gather the exact hardware in the bill of materials.
  3. Retain the three pivots. Assemble the base pivot, crank pin and slider wrist using their separate shoulder sleeves and specified thrust washers. Fit the supplied 12 mm lift spacers at both rod joints. Use the exact M4 screw lengths in ASSEMBLY.txt; do not substitute a longer base-pivot screw. Tighten the nuts against the sleeves so the moving parts remain free.
  4. Capture the slider. Bolt both rails and their top covers to the base. Keep the rod eyes in one plane and confirm that screw heads are flush, the carriage cannot lift out, and nothing binds.
  5. Test slowly by hand. Turn through a complete cycle without forcing it. Inspect the clearances and retention at both ends of travel. Record the printer, material and fit changes before experimenting further.

Designed and checked numerically; not physically printed, fitted or durability tested. This is not print-in-place, a rated tool, or a verified gearbox.

Get Guassia Asset EngineShare a fit test or report an issue

Model, inspect, save

In Asset Engine, start with a supported shape or import, inspect it up close, edit a copy, and save the source locally. The Guide button takes you directly to the relevant controls.

Appearance and fabrication

Gaussian appearance does not guarantee a solid interior. Manufacturing export creates a separate surface representation. Check units, closed surfaces, separate parts and slicer layers before printing.

Bring your own asset

In Guassia, open My local assets and choose Edit in Asset Engine. The original file is preserved. A local import does not create a store purchase or change a third-party license.